Answered! Medium access control at ethernet network. Transport stack of The OSI model and IBM model difference….

Medium access control at ethernet network. Transport stack of The OSI model and IBM model difference.
1. Audun access cov f20 of ether nuf The osi noolel and a CM tette IAM model differ luce.

Expert Answer

 

1. The medium access layer was made necessary by systems that share a common communications medium. Typically these are local area networks. The MAC layer is the “low” part of the second OSI layer, the layer of the “data link”. In fact, the IEEE divided this layer into two layers “above” is the control layer the logical connection (Logical Link Control, LLC) and “down” the control layer The medium access (MAC).

In Layer 2 of a network, the Media Access Control (MAC) sublayer provides addressing and channel access control mechanisms that enable several terminals or network nodes to communicate in a network.

The MAC sublayer acts as an interface between the logical link control (LLC) Ethernet sublayer and Layer 1 (the physical layer). The MAC sublayer emulates a full-duplex logical communication channel in a multipoint network. This channel may provide unicast, multicast, or broadcast communication service. The MAC sublayer uses MAC protocols to prevent collisions.

In Layer 2, multiple devices on the same physical link can uniquely identify one another at the data link layer, by using the MAC addresses that are assigned to all ports on a switch. A MAC algorithm accepts as input a secret key and an arbitrary-length message to be authenticated, and outputs a MAC address.

A MAC address is a 12-digit hexadecimal number (48 bits in long). MAC addresses are usually written in one of these formats:

MM:MM:MM:SS:SS:SSMM-MM-MM-SS-SS-SS

The first half of a MAC address contains the ID number of the adapter manufacturer. These IDs are regulated by an Internet standards body. The second half of a MAC address represents the serial number assigned to the adapter by the manufacturer.

Contrast MAC addressing, which works at Layer 2, with IP addressing, which runs at Layer 3 (networking and routing). One way to remember the difference is that the MAC addresses apply to a physical or virtual node, whereas IP addresses apply to the software implementation of that node. MAC addresses are typically fixed on a per-node basis, whereas IP addresses change when the node moves from one part of the network to another.

IP networks maintain a mapping between the IP and MAC addresses of a node using the Address Resolution Protocol (ARP) table. DHCP also typically uses MAC addresses when assigning IP addresses to nodes.

2.
Transport layer of TCP/IP is similar to transport layer of OSI Model. It breaks information into segments. Applications can write and read to this layer. It also takes two important decisions-

The communication should be reliable or not. For reliable communication TCP protocol will be used and for non reliable UDP protocol will be used. Non reliable communication is faster than reliable communication because it doesn’t require acknowledgement for every segment. It also decides the data transmission should be on parallel path or single path.This layer also decides the port number for the source and attach with ip address so that we can come to know from which application information is coming from. It adds header information to data.

So objective of this layer is deliver the complete message from source to destination.

In OSI model the transport layer guarantees the delivery of packets but in TCP/IP model the transport layer does not guarantees delivery of packets.

Still stressed from student homework?
Get quality assistance from academic writers!